LINK TO OTHER HOW-TO GUIDES…
Tiling preparation advice for a successful tiling project
Preparation is key, before you actually get your hands on the tiles there’s three things you should do to prepare:
Measure the area
You’ll want to make sure you have accurate measurements before you order your tiles to prevent ordering too many/ too few.
Step 1 – Measure the height and width of the area you are going to tile with a tape measure, times the two sizes together and this is the number of square metres you will need to order.
Step 2 – For irregular sized rooms, divide the area up into different segments and work the areas out individually, add the resulting numbers together to calculate your square metre requirements.
Step 3 – Measure any doors, windows or obstructions and take the size away from the total.
Step 4 – Allow for an extra 5-10% to account for any breakages and cuts (for larger tiles you may need to account for more).
The tiling surface needs to be prepared before you can start affixing tiles, ensure you follow each of these steps:
Step 1 – Clean: Use a damp cloth to remove surface contaminates. You can use a suitable degreasing agent, however you should always wash down after with clean water.
Step 2 – Dry: Ensure the background and surface is fully dry.
Step 3 – Sound/ solid: Cut away any loose areas on the surface to ensure a stable base when affixing tiles.
Step 4 – Flat: Ensure the surface is flat with no more than 3mm in variation over a 2 metre edge. On floors, the use of a levelling compound may be recommended.
Step 5 – Prime: Depending on the adhesive, priming the surface might be required, always check before starting.
*Optional* – Waterproof: In wet areas the use of a waterproofing product is recommended, follow the manufacturer’s recommendation for application.
Finally, we need to make a tile staff, this length of timber will help you to gauge how your tiles will fall around obstacles such as windows and doors. Here’s how to make one:
- Lay your length of timber on a flat surface
- Place a tile on the length of timber flush with the timbers edge
- Mark the timber at the end of the tile with a pencil
- Ensure that the marks are square
- Position a spacer at the edge of the tile and place a second tile against that, again mark the timber
- Repeat this process until you reach the end of the timber
- Cut off any excess timber
You now have a tile staff, which will come in handy when working around tricky areas.